Heating pot

1. Air inlet pipe and outlet pipe joints are leaking. When tightening the nut does not solve the problem, add or replace the packing. 2. The pressure gauge and safety valve should be checked regularly, and if there is any fault, they should be replaced or repaired immediately. 3. After 50 hours of use, the gearbox should be removed to drain off the lubricating oil, rinse with kerosene or diesel, and add 30#-40# to clean it. Engine oil, after 150 hours of use, change the oil for the second time, and then change the oil every 1000 hours or so depending on the specific situation. 4. If the anti-rust paint is peeling off, it should be painted and painted on the outer pot immediately. X55-3 aluminum powder vinyl water-resistant paint is recommended. 5. After the pot has been used for 5 years, it is recommended to conduct a safety water pressure test. Request to proceed. The pressure P water of the hydraulic test is determined according to the following conditions: When the rated working pressure P is <0.6Mpa, P water=0.15Mpa; When the rated working air pressure P amount=0.6-0.8Mpa, P water=P amount+0.3Mpa 6. The outer pot body of this pot is made of 3～5mm thick stainless steel, when the outer pot is thinned to less than 2mm after years of corrosion , Should stop using. 7. The welding of stainless steel in this pot and the welding of stainless steel and other steel materials should use stainless steel electrodes Ao 102, Ao 107, Ao 132, Ao 137. Other grades should not be used.